Denver · Wolf
Cooktop Repair
Gas, induction and electric Wolf cooktops: electrodes, sealed burner heads, radiant elements, inverter boards and touch glass that has stopped answering a finger.
Flat $89 service call — the visit and a full diagnosis. What the repair itself runs is set out band by band below.
In your words
How this one gets described on the phone
- An induction zone chimes and drops out halfway through a boil
- One sealed burner catches late, with a small pop each time
- A radiant element stays at full output wherever its knob points
- The glass was wiped down and nothing on the panel responds now
And what it usually turns out to be
An induction zone beeps and quits partway through a boil
Heat, not the pan. The cooling fan under the glass packs with dust and kitchen grease and the inverter protects itself. Cabinet airflow behind the unit matters as much as the fan.
One element stays at full heat wherever the knob is
A welded relay. Switch that circuit off at the breaker until it is dealt with — an element stuck on is the one fault worth being blunt about.
I wiped the glass and the touch controls stopped answering
Water under the trim reaching the ribbon connector. Often it dries out and reseats; it does not usually mean a new board.
The other three benches
Where it gets driven
Across the centre and south-east of the city and out through the suburbs on three sides — the sector, place by place.
What it costs
What the repair itself runs, once we know what it is
The service call is $89 flat. It buys the trip and a finished diagnosis, and it comes off the repair price the moment you say go ahead.
- Igniter or spark module $180 to $470
- Burner valve or orifice service $240 to $580
- Oven thermostat or sensor calibration $180 to $470
- Convection fan or motor $270 to $690
- Control board or touch panel $420 to $870
- Door hinge, glass or seal $300 to $660
Every line is a range because the part that has actually failed decides where inside it a job lands, and that is settled with the panel off rather than over the phone. Once it is settled you get one figure covering parts and labour, you agree to it before a tool comes out or a part is ordered, and the $89 you have already paid for the visit comes off it.
One comparison, then we will leave it: a comparable professional range, before installation and ventilation work, costs $8,300 to $18,490. Against that, most of what stops a Wolf range is a part inside it — an igniter, a fan bearing, a hinge spring — and the range itself is fine.
Reviews
Cooktop repair reviews
5.0/ 51,436 reviews
Induction kept dropping out whenever the tall pot went on. Underneath the glass the cooling fan was packed with dust and grease. He cleaned it, ran it an hour, and showed me how to keep it clear.
Ingrid F.Golden Triangle
Wiped the glass one evening and the touch controls stopped answering entirely. Water had crept under the trim as far as the ribbon connector. Dried and reseated. No new board, no drama.
Oksana P.Virginia Village
Back burner burned yellow and put soot on my kettle. Wrong orifice for our elevation, fitted by whoever did the loft conversion. He changed it, and the flame is blue and quiet again.
Weldon P.Golden Triangle
$89 service call
Book a cooktop repair visit
Model number and the symptom is enough to start. The Denver line is answered 24/7; the $89 comes off the bill once you approve the repair.